I remember a while back someone making one but never teased us with pics. Mine is about 90% finished still needs a skid plate for the bottom loop and two smaller tubes for the sides the bend down to the main tube for head light protection.
Sent you a pm. or jsut contact me at wadams@westerncon.comdzp said:Looks good bro, got any profile pics? How far back does the bottom hoop go?
I will snap a few tonight. The attachment it the uni-body is not complete. Still pondering that, so in the profile shot dont mind the long attachment plates they are for a winch bumper I make for xj's and shhhhh don't tell no one but for Xterra'sFunkSkunk said:Hey, nice hood loovers!! looks pretty trick! How about that profile shot and some close ups of the details.
so the top main tube looks as if it is free floating so to speak. Whats the two plates for on the down tubes that are u-bolted on for?homerscj7 said:there are some pics of mine here...
http://www.cardomain.com/id/erikrs301
I didn't make it, bought it second hand. The mounts are 2 plate on either side welded to a square tube at the bottom and then 2 round tube come off of that up into the bumper. It was designs to work with the stock bumper in place.
homerscj7 said:That plate u-bolted on is just to block junk front getting into the engine area through those holes in the front cross-member. Here's a pics from before the plate...
Ahhh yes you did mention that before. Either way I plan on working on it a lil bit tonigt son I will post a few more tomorrow.homerscj7 said:I think the reason the main tube does not have any more supports back to the mount is because it was made to work with a stock bumper in place.