Jeep Enthusiast Forums banner

What did you do to your ZJ today?

4M views 55K replies 2K participants last post by  98ZJ 
#1 ·
This thread is to serve as an inspiration to others modifying their ZJ's. Pretty simple, just post what you did to your ZJ today!


Today I shamefully took my Jeep to get the oil changed because it was to hot to change it myself.
 
#31,464 ·
#31,465 ·
Realized that after the pretty heavy storm we had this morning, there may be a small leak somewhere in the Jeep above my drivers seat. I've got leather seats and some of the piping is a bit worn, sat down and immediately realized that the foam soaked up some water. No where else in the car seems to be wet though. I've got a sunroof so I'm wondering if that's the culprit?
 
#31,466 ·
IRO HACK AND TAP SYE Vs. CV Cardon drive shafts
What should I do guys my entire lift and crossmember is IRO and I've got a JrMechanic built 242 with vibration after 45mph. I've looked at both options and the IRO is alot of work but i know the vibe will go away and with the CV Shaft is no work at all but i might still have a lil vibration. I'm stuck with this decision and i need a lil help from the elders on the forum please.
 
#31,467 ·
Realized that after the pretty heavy storm we had this morning, there may be a small leak somewhere in the Jeep above my drivers seat. I've got leather seats and some of the piping is a bit worn, sat down and immediately realized that the foam soaked up some water. No where else in the car seems to be wet though. I've got a sunroof so I'm wondering if that's the culprit?
There is no other place for water to get in up there besides the sunroof. Maybe a clogged drain. I would get a bucket of Damp Rid and leave it in your ZJ with the windows up out of the sun.If you have to leave it in direct sun then leave the windows open. It can steam up and your headliner will fall down.
 
#31,470 ·
IRO HACK AND TAP SYE Vs. CV Cardon drive shafts
What should I do guys my entire lift and crossmember is IRO and I've got a JrMechanic built 242 with vibration after 45mph. I've looked at both options and the IRO is alot of work but i know the vibe will go away and with the CV Shaft is no work at all but i might still have a lil vibration. I'm stuck with this decision and i need a lil help from the elders on the forum please.
Pinion angles good?
 
#31,472 ·
There is no other place for water to get in up there besides the sunroof. Maybe a clogged drain. I would get a bucket of Damp Rid and leave it in your ZJ with the windows up out of the sun.If you have to leave it in direct sun then leave the windows open. It can steam up and your headliner will fall down.
I guess there are some other spots that are kind of damp. Under the car mats especially, though I think that's from the winter season and it not getting warm enough to dry them out completely. (Or it could be from this leak as well)

But I've never had this happen. Another thought was maybe the mass amounts of water could have caused an overflow in the drainage system for the sunroof?
I'll try the damprid, they sell it where I work. Thanks for the suggestion!
 
#31,475 ·
Ordered 2 new driver's side and 2 new passenger's side headlight assemblies for George & Weezy today.
$18.50 each, including bulbs.
It will be nice to be able to see at night again!!! LOL
 
#31,476 ·
Which series did you go with?
Those ones you recommended, the TS-D1720C and TS-D1620R set. I'll probably throw in the amp next paycheck, or next month or something. I don't think I'll strictly need it until it's time to add a subwoofer. Meanwhile I need to save money for brakes and a hub assembly and a kolak exhaust.
 
#31,479 ·
Damn, thats nice, gotta remember that next time I blow a pump bracket.
 
#31,480 ·
millco88 said:
Bought This bracket on ebay. Super cool and strong looking> hope I dont break any more power steering brackets.
That looks like one of MurdaJ's brackets.

Sent from my iPhone 6 using JeepForum
 
Top