This shows as my first post. However I 'm sure I reg years before . Well I'm getting older so may have my mind all muddled up .
I have several jeeps .Wifes 2000 4.0 xj , 89 4.0 xj , 89 parts 4.0 xj , 87 2.5 mj .
Been thinking about what to do with them . Also have a wj that has a 4.7 that is another problem in it's own . Looking at rebuilding that motor if it is still good.
The 2000 runs fine . One 89 may have a bad head gasket , other 89 was for parts is rusted and i never started it . the mj has a worn out 2.5 4 speed.
So what do I do strip one of the 89s for the mj with has very little rust on it ?
Install a om617 in the mj
I have a 3 inch lift for a 89 xj so that will be getting used in something .
Also have a couple om617engine and tranny's put up
I do not trail drive or extreme 4x4 stuff. Just down my drive way mainly . Which some may say is a trail and not a road . lol
Looking at ideals as hate to just let them all sit
T.I.A
I have several jeeps .Wifes 2000 4.0 xj , 89 4.0 xj , 89 parts 4.0 xj , 87 2.5 mj .
Been thinking about what to do with them . Also have a wj that has a 4.7 that is another problem in it's own . Looking at rebuilding that motor if it is still good.
The 2000 runs fine . One 89 may have a bad head gasket , other 89 was for parts is rusted and i never started it . the mj has a worn out 2.5 4 speed.
So what do I do strip one of the 89s for the mj with has very little rust on it ?
Install a om617 in the mj
I have a 3 inch lift for a 89 xj so that will be getting used in something .
Also have a couple om617engine and tranny's put up
I do not trail drive or extreme 4x4 stuff. Just down my drive way mainly . Which some may say is a trail and not a road . lol
Looking at ideals as hate to just let them all sit
T.I.A