Jeep Enthusiast Forums banner

Tj dana 30 axle question

454 views 3 replies 3 participants last post by  jpin86 
#1 ·
I am going from 3.07 gears to 3.73's (Daily driver going to run 31's), 2003 TJ. I got a dana 35 with a super 35 kit ready to install. I found a 1997 dana 30 front with 3.73's. It looks like the calipers and pads are the same between the 1997 and 2003 dana 30, but the hub bearings and rotors are different. Does anyone know if I can put my 2003 hub bearings and rotors on the 1997 axle and bolt it in?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top