I upgraded my dash some time ago and have had numerous problems with wiring my LEDs (and gauges). One of my problems is that the Parking Brake light doesn't come on when push in the parking brake. I know the ground is fine because high beam LED and the brake LED use the same ground and the HB light comes on when I activate the HBs. I also checked the back of the LED and the wires look intact.
Before I did the upgrade the Parking Brake dash light worked fine. I looked under the dash to see how the light could be (??) activated. The device that I've singled out does not look damaged or corroded.
Frankly, I really don't know what I'm looking at or looking for. Could it be the brake light switch, relay, corroded wires? Like I said earlier, the light worked fine before I did the "upgrade".
Here is the switch I'm talking about:
http://www.jeep4x4center.com/brake-lamp-switch-w-o-cruise-control-3215938.html
Any thoughts? Thanks.
Before I did the upgrade the Parking Brake dash light worked fine. I looked under the dash to see how the light could be (??) activated. The device that I've singled out does not look damaged or corroded.
Frankly, I really don't know what I'm looking at or looking for. Could it be the brake light switch, relay, corroded wires? Like I said earlier, the light worked fine before I did the "upgrade".
Here is the switch I'm talking about:
http://www.jeep4x4center.com/brake-lamp-switch-w-o-cruise-control-3215938.html
Any thoughts? Thanks.