Jeep Enthusiast Forums banner

Dead in the water again.

581 views 3 replies 2 participants last post by  the6ws 
#1 ·
I need some help. I have 1984 j10 that will not turn over. I have fried two starter relays in the last several months. Currently I have a new relay, starter, battery, and alternator. When I try to turn the truck over the relay buzzes and that is all. Before when the relays went they would rattle. With a volt test I get 12.4 to the relay and 0 at the other terminals. With acc on I get 12.4 to the relay and .2 at all but the red terminal at the top which is 7 volts. Cranking, all the terminals read 4 volts except the battery main. What is going wrong? I need some help, please.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top