Jeep Enthusiast Forums banner

2nd Annual Spring Uwharrie OHV Jamboree

20K views 456 replies 20 participants last post by  LifeProof 
#1 ·




Saturday, March 30th. Trails open early on Friday the 29th. Address for the Eldorado Outpost is 4021 N Carolina 109, Troy, NC 27371.

Clubs, Dealers, Parts Manufacturers, Swap Meet, UORTC 4x4 Games, Helicopter rides, Off-Road Test Track, ect.

Fly-over from the Fall Jamboree. I'm partial because you can see my rig on it.



VVV Click icon for more information. VVV


So, who's going? I'll be there with 3 rigs and some ATV's if it all works out.
 
See less See more
1 3
#57 ·
SandKing said:
Oh lol, yeah I've heard of daniel, didn't know it was the same thing lol. I heard stories that for a tj you need at least 35's with excellent lines or spotter or at least one locker
Anyone who thinks that is either uninformed, ignorant, or doesn't know what the hell they are talking about. Take your pick. :D I've been up Daniel in my TJ when it was stock on 31" ATs.
 
#66 ·
Jankoid said:
Well if your dad is paying then go ahead!
That's the thing...idk if he is. He keeps saying he likes it and would rather go that route but he hasn't said anything about buying it :laugh: I have a pretty good opportunity to get a job up at school so if that goes through I may just buy it. Me nor my dad have never welded before so the normal 8.8 swap would be a huge challenge.

Sent from my iForum using JeepPhone
 
#80 ·
Suspension Lift: 2.5"- 3.5"

Shaft Options: Superior C-Clip Elim Kit (+$700.00)

ADD DIFF COVER: SOLID COVER (+$75.00)

Driveshaft Style : CV-SYE

ADD LOCKER: Full Detroit- 187C-145A (+$640.00)

Reman Unit with New Gears: F8.8- 4.88 (+$535.00)

FINISH: Flat Black

Select TJ Bracket Kit: ECGS TJ Brackets

$2,650
_________________
TJ D44 Rear Axle Assembly 5.38 ratio; With Detroit Locker

îž‹Dana 44 TJ Rear Axle Assembly
îž‹ 5.38 gear ratio
îž‹ Detroit Locker
îž‹ G2 30 spline axle shafts
îž‹ 1310 Series U-Bolt Yoke

$2,353

cut and paste from 4wheelparts
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top