Jeep Enthusiast Forums banner

What did you do to your TJ today?

11M views 119K replies 9K participants last post by  OldJeepBum 
#1 ·
OK, I stole the idea from the YJ forum but it's a great idea so let this thread be an inspiration for all of us doing mods, maintenance, or repairs to our TJ's! :D

Personally, I installed my trusty Uniden CB into my new Rubicon. :thumbsup:
 
#65,666 ·
#65,671 ·
Heard a "knock" when I was turning coming from the front passenger side: UJoint going bad. I got the old UJoint out and sure enough, one cap was full of rust instead of grease... So I ordered Chromoly shafts for the front axle. :D
 
#65,673 ·
Ordered a 6" antenna so it wont hit my windsheild kc light
I just bent mine back nice and neat that way it's still factory height for reception.

Today I threw on my seatback organizers I got from Ocean State Job Lot for $7. It's for a full back seat so I just cut out the middle section and threw the ends on the seats. I wish I could afford the MOLLE setups but it's not in the budget. What do you think?
 

Attachments

#65,674 ·
I just bent mine back nice and neat that way it's still factory height for reception.

Today I threw on my seatback organizers I got from Ocean State Job Lot for $7. It's for a full back seat so I just cut out the middle section and threw the ends on the seats. I wish I could afford the MOLLE setups but it's not in the budget. What do you think?
i think you get what you pay for. they look cheap to me but thats just my opinion
 
#65,676 ·
I just bent mine back nice and neat that way it's still factory height for reception.

Today I threw on my seatback organizers I got from Ocean State Job Lot for $7. It's for a full back seat so I just cut out the middle section and threw the ends on the seats. I wish I could afford the MOLLE setups but it's not in the budget. What do you think?
if you look at the ad, its a backseat organizer, so it goes on the back of the front seats as shown in the pics but it does look better with the middle cut out
 
Top