Jeep Enthusiast Forums banner

Liquid CO2 tank fittings

4K views 6 replies 2 participants last post by  BigWaylon 
#1 ·
I've looked all over and can't find any regulators for my newly acquired co2 tank. The regulator I have for it only goes to 60psi which is fine for airing up tires and using the air nozzle. I need (want rather!) a regulator that goes up to at least 100psi so I can run tools off this. Here's pics of what I have...

 
See less See more
2
#2 ·
I assume with air tools you want adjustable?

I have a 150PSI fixed on mine...

  • welding supply shops probably have them...
  • Stu has a link on his site to where he bought one (I'll go look in a minute)...
  • you can get them here: http://www.offroadair.net/products.html
  • and I bet PowerTank sells theirs seperately, too...

Greg
 
#5 ·
htownjeep said:
Thanks...I've been striking out at welding shops. Don't know why I didn't look at Stu's site first! :brickwall :brickwall He's done just about everything!

Thanks!
my setup is one of the "The Source" (the offroadair.net site)...

they do sell the adjustable regulators...

Greg
 
#7 ·
htownjeep said:
Thanks a ton! They have what I need it appears. What would be the harm in getting the 150psi static one? Would that mess up my air tools?
yep...

I think most air tools run in the 90PSI range (not sure, just best I can recall)...

150PSI is too much for most air tools on the market...but it works great on tires...

Greg
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top