Jeep Enthusiast Forums banner

What did you do to your TJ today?

11M views 119K replies 9K participants last post by  OldJeepBum 
#1 ·
OK, I stole the idea from the YJ forum but it's a great idea so let this thread be an inspiration for all of us doing mods, maintenance, or repairs to our TJ's! :D

Personally, I installed my trusty Uniden CB into my new Rubicon. :thumbsup:
 
#1,382 ·
MarineMurdock said:
Finally got those Hella 500s hooked up.

BTW, did you know the Hella 500s are $10 cheaper at Wal-mart than Qaudratec, not including shipping.
I ordered a dual toggle racing switch panel off ebay. My locker bypass and lights are going in it. Not sure where I am mounting it yet.
 
#1,383 ·
Finished the wiring on these KC's on my Jeeperman bumper

 
#1,386 ·
Monrozombi said:
Painted my headlight bezels



Painted my license plate holder



and also painted my factory side steps to match my krylon fusioned fender flares

I can't tell if that is a dealer sticker on the back of your jeep or not, but if it is, you need to add taking it off as a "Stuff you did to your TJ today"(Unless you like them).
I can't stand the fact that the dealers put that junk on there. Sometimes they are very difficult to remove. The headlight Bezels look really nice BTW.
 
#1,387 ·
MarineMurdock said:
I can't stand the fact that the dealers put that junk on there. Sometimes they are very difficult to remove. The headlight Bezels look really nice BTW.
When I bought my 2000 new part of the deal was "No Stickers"... guess what it came out with a sticker. I made them take it back in the shop and take it off. $XX,000 is too much to pay to also be an advertisement!
 
#1,388 ·
Finally...

I finally got around to putting on my new EGR 6.5" fender flares. They've been setting in the garage for two months. That 2-hour job they talk about took me nine (if you count an hour-and-a-half trip to the hardware store for $27 worth of stainless capscrews and washers that I ended up not using much of). I'm happy with them though.

Before (w/ Gambler rims)...



After (w/ Cragar Soft 8's)...

http://www.cardomain.com/member_pag...ages/4/web/2332000-2332999/2332098_2_full.jpg
 
#1,392 ·
I ripped out my Dana 35 and started to triangulate my upper long arms to attach to my New Rock Jock 60.
Cut out the muffler because it now interferes with the upper arms.
Set it back down to measure for the drive shaft (needs to be shortened)
Checked ground clearance gained 2”
Got board with the rear-end and started my front hub conversion.
Got tired and came here.
 
#1,395 ·


Finished the install of my A to Z Fabrication rear bumper and tire carrier. Next up are frame tie-ins. Once again, great work, Zach!
 
#1,398 ·
took the doors off for the first time and had the top down and just drove around.. WOW what a feeling and the looks i get.

and i almost lost my phone when i took a turn i placed the phone on the seat and i forgot the doors where gone so the phone flew to the side but it got cut between the seat and the tub so it just landed on the floor inside the jeep :D

i cant wait to take the doors off agian.
 
#1,400 ·
I finally found a leather steering wheel cover that I liked, kind of a PITA to stitch it on though. :cool:

 
Top