Jeep Enthusiast Forums banner

What did you do to your WK/XK today?

Tags
radiator
2M views 19K replies 1K participants last post by  99sajeep 
#1 · (Edited)
Deleted
 
#10,929 ·
Put on K&N intake. All good but don't like how tight the sensor wire to air tube is...
 
#10,932 ·
Yesterday, after 5 days of calls and fits, I finally got the new Kenwood stereo mounted and programed in the dash! If it weren't for that damned steering wheel controller, I would have it done last Sunday. Aside from the programming fiasco, the new unit is fabulous! Built in Garmin GPS, touch screen controls, bluetooth connectivity for both the phone an ipod functions! Best mod to date! Tuesday, George goes in to Desert Rat for new rear airbags.

*Note: do NOT buy the Firestone bags! The company does NOT stand behind their product! (wished I had known that 6 months ago)
 
#10,934 ·
Installed a rear Whelen Halo LED tail light kit (originally for Crown Vic's) combo park/tail and warning light
 
#10,942 ·
It's at the powdercoater right now putting on some satin black.

I actually found this one by fluke. I had arranged a group buy recently that got canned and I had to back out of my order due to some unforeseen family circumstances. Anyway, wound up coming across this one and I wasn't going to complain. Drove 6 hours today round trip to pick it up.

Sent from my iPhone using JeepForum
 
#10,943 ·
Color matched my chrome grille to the rest of the car and installed my grille from aspen creek. Also threw in a K&N filter in the intake. Got my Gibson exhaust from Kolak as well and plan to get that done this week!
 
#10,953 ·
I think this may be the next project on my list of things to do. I think I still have some white LED's laying around.

Looks good!
 
#10,946 ·
Jeepforthewin said:
Pics or it didn't happen...you know the rules! ;)
It's at the powder coater but I'll grab pics as soon as I get it back.

Sent from my iPhone using JeepForum
 
#10,948 ·
Replaced my lower ball joints, what a pain! Hardest part was just separating the knuckle from the lower ball joint. I also did my inner tie rod. Ball joints are made by ProForged, and inner tie rod is Moog. The PF ball joints are just as good as the moog ones but apparently you need to modify something to get the moog ones to fit according to some reviews you need to grind away a bit to make the c clips fit. Anyways now I just need an alignment!

Sent from my Jailbroken iPhone using JeepForum
 
#10,949 ·
I did the cargo LED's about a week back using small panels hot glued to the inside of the trim.





Here is the bulb for the Whelen LED's
 
#10,954 ·
JeepCK said:
I think this may be the next project on my list of things to do. I think I still have some white LED's laying around. Looks good!
Thanks. Word to the wise, the positive wire is more of a magenta with white strips than a red with white stripe. At least on mine.
 
#10,957 ·
Ok guys, got a check engine light in the wifes 07 commander, did the key dance and it showed a P0202 code which is an injector issue #2 cylinder. Should I mess with cleaning it or just replace it? Will one brand new injector throw off the other 5 (3.7 v6)?? I already tried treating the gas with injector cleaner and the light went off for a day or so....if I pull it to clean it I might as well spend the $40 and replace it right?
 
Top