Jeep Enthusiast Forums banner

BJ grease fittings rubbing on boot

942 views 6 replies 5 participants last post by  reichhartkg 
#1 ·
I just put in new ball joints that I bought from Advance Auto. They choose the parts based on their computer.

All four joints have grease fittings. When I put the axles back in, I found that the grease fittings on the lower joints rub on the boots.

Anyone else run into this? Is there a way to work around it?
 
#6 ·
My Moogs were the same way. Just install the zerk, lube the ball joint and screw on the cap screw instead to clear the CV Boot.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top