Jeep Enthusiast Forums banner

select trac to command trac

962 views 3 replies 3 participants last post by  biffgnar 
#1 ·
Hey , I swapped out my bad dana 30 front with solid axles(select trac) , to a dana 30 with command trac(2 piece axle shaft). It was free , but now 4wheel dr kinda screwy. Just wondering if can make work , or not worth trouble . Thnks in advance , any info would be appreciated , have both shop manuals(engine , electrical) not much bout shift motor on frnt axle , guessing works on vacume , so hopefully can make work.
:cheers2:
 
#2 ·
Yes it runs off vacuum. It can also be made to run off a cable.

I wonder I if its possible to use the solid shaft from the other D30? Then just seal the hole in the axle tube.
 
#4 ·
I wonder I if its possible to use the solid shaft from the other D30? Then just seal the hole in the axle tube.
This. XJ D30s into TJs is a common thing to do since they are HP. While people look for the newer ones that are not disconnect they can't always find them or find a better deal on a disconnect. You should be able to find plenty of write ups on it.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top