Jeep Enthusiast Forums banner

copper washers for brake banjo bolts?

4K views 1 reply 2 participants last post by  rjbruzan 
#1 ·
Where do I get 'em? (and does anyone have the sizes required for a stock XJ.) I'm troubleshooting a brake issue and would like to be able to disconnect and reconnect hoses therefore having a stash of these washers would be most helpful; however, every FLAPS I've tried either says "bring them in and we'll match them up" or "no, we don't have those." Obviously I'd like to have them on hand before I start.

I suppose I could always anneal them with a plumber's torch, but who knows how many times that's been done before?

Seems to me the typical "copper washer assortments" tend to have washers that are way too thick for brake banjo applications...

thanks!
 
#2 ·
I know its nice to replace them but have reused many times as long as they are very tight they wont leak.

Ron
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top