What did you do to your JK today? - Page 492 - JeepForum.com

 91Likes
 
LinkBack Thread Tools
post #7366 of 24842 Old 06-06-2011, 12:07 AM
kjamesm
Registered User
2010 JK Wrangler 
 
Join Date: Dec 2008
Location: Arlington
Posts: 56
folded the windshield went for a drive.

Attached Thumbnails
IMG-20110605-00356.jpg   IMG-20110605-00357.jpg   IMG-20110605-00358.jpg  

2010 JK
2.5 RC BB
1.5" spacers
315-75-16 Duratracs
kjamesm is offline  
Sponsored Links
Advertisement
 
post #7367 of 24842 Old 06-06-2011, 12:31 AM
1222
Make mine a Jeep!
 
1222's Avatar
2012 JK Wrangler 
 
Join Date: Jul 2007
Location: Henderson
Posts: 13,239
Get hit in the face by any bugs? Looks kinda fun, I bet there were a lot of heads turned as you drove by.
1222 is offline  
post #7368 of 24842 Old 06-06-2011, 06:35 AM
jdcouts
Registered User
2010 JK Wrangler 
 
Join Date: Jan 2011
Location: Evansville
Posts: 38
Quote:
Originally Posted by voodooJK View Post
Have you thought about getting a bikini? For your Jeep, I mean.
I run one all summer when the top is off. That will stop most of it.

Well other than the 3" of water that was standing in the floorboards it dried out pretty well. Pulled the plugs so it took care of the water.

I have a bikini on order, it says itll be here tomorrow.
jdcouts is offline  
post #7369 of 24842 Old 06-06-2011, 06:46 AM
ArmyFireFighter
Registered User
1998 XJ Cherokee 
 
Join Date: Feb 2008
Location: Sackets Harbor
Posts: 540
Quote:
Originally Posted by jeeperjk View Post
I read that as "Driver's Side tail light"...
correct. Driver Side.
ArmyFireFighter is offline  
post #7370 of 24842 Old 06-06-2011, 07:03 AM
marmotmb
Registered User
2007 JK Wrangler 
 
Join Date: Apr 2008
Location: AB
Posts: 160
Quote:
Originally Posted by molshove View Post
Any suggestions for testing/verification? Wouldn't mind correcting before failure
use a screw driver, put the metal tip on the bolt that holds the wheel in place, put your ear to the end of the screw driver. Move the screw driver around to the different pulley wheel bolts and listen, you will hear the difference.

I replaced a few myself, but then when I mentioned it at the dealer they replaced them under warranty.

I think my problem was twofold. I had a high temp problem, poor engine cooling for a long time (Plugged up rad exterior, replaced under warranty) in addition it seemed to always happen when I washed the engine bay (even though I didnt' spray right at them, a bit of water was enough)

they are about $30 CAN and takes 5 minutes to replace. I keep a few in my garage now, but since cooling was fixed I haven't had to do it again.

Pro Comp - Hypertech Programmer / 2.5" Teraflex coil lift & 1" M.O.R.E Body Lift / 315/75R16 Pro Comp Mt. Extremes / 16" x 8" Pro Comp Series 52 (Black) / Pro Comp steering stabalizer / Air Raid Cold air intake / Ace Enginnering and Fab Front stubby with bull bar / OR Fab Rear tire carrier / 2 Blitz Jerry Can / HI lift jack / Cherry Bomb 2.5" Exhaust and Custom Tail pipe / KC Daylighter 6" 130 Watt with Driving lense / Shifter boot trim ring bolt mod / Rear Bumper gap mod / Mirror drill hole mod
marmotmb is offline  
post #7371 of 24842 Old 06-06-2011, 07:29 AM
jeeperjk
Web Wheeler
2009 JK Wrangler 
 
Join Date: May 2008
Location: Browns Mills
Posts: 1,493
Quote:
Originally Posted by jdcouts View Post
I have a bikini on order, it says itll be here tomorrow.
Is it itsy bitsy teenie weenie yellow polka dotted?
jeeperjk is offline  
post #7372 of 24842 Old 06-06-2011, 07:36 AM
SomeBeach
Registered User
2007 JK Wrangler 
 
Join Date: Aug 2007
Location: Near PGH
Posts: 278
Replaced this......driver's side downstream o2 sensor. Dang Squirrels!
http://www.jeepforum.com/forum/f7/wh...s-now-1199436/
Attached Thumbnails
o2sensor.jpg  
SomeBeach is offline  
post #7373 of 24842 Old 06-06-2011, 07:50 AM
Joevacs
Registered User
2010 JK Wrangler 
 
Join Date: Sep 2010
Location: Hickory
Posts: 1,240
Quote:
Originally Posted by jdcouts View Post
About to see how wet a Jeep can really get. Stuck at work, no doors, no top and it is pouring outside. Not gonna be a very fun ride home.
hehe... I've been very lucky. I've had the top off and no doors since Memorial day weekend. So far no rain except a short storm yesterday evening. I carry a 12'x14' tarp folded up in the back just incase.

2010 Rubicon, 4" lift, Currie control arms and trackbar, 40" Procomp MTR
Joevacs is offline  
post #7374 of 24842 Old 06-06-2011, 09:30 AM
SJMUDWRANGLER
Registered User
2011 JK Wrangler 
 
Join Date: May 2011
Location: WILLIAMSTOWN
Posts: 118
YESTERDAY i washed and waxed it it try to keep bug splatter removal easier. Today ordered my 2.5" front coil spring spacer and 1.75 rear spacer. from top gun customz

2011 JEEP JK SAHARA UNLIMITED, BLACK ON BLACK, TRAILER HITCH, LOCKING FUEL DOOR, HYLINER FRONT ROCK BUMPER WITH LIGHT BAR,AND WINCH MOUNT,2.5"/2" TOPGUN CUSTOMZ LIFT LEVELING KIT,TINTED WINDOWS,ZONE 3"SHOCKS





future mods: SPRINGS,WHEELS,TIRES,SNORKEL,
SJMUDWRANGLER is offline  
post #7375 of 24842 Old 06-06-2011, 09:46 AM
Bubblegoose1
Registered User
2007 JK Wrangler 
 
Join Date: Sep 2008
Location: Kirkland
Posts: 766
Rebuilt Teraflex front lower control arm joints, at the axle. Easy work; 15 min per arm. Notched transmission skid and crossmember to allow more front driveshaft droop. Two nice ribbon stripes in the driveshaft from flexing this thing. Checked front brakes for an annoying chirp, and lubed RCVs.
Attached Thumbnails
ForumRunner_20110606_084100.jpg   ForumRunner_20110606_084331.jpg  

RIPP GEN 2 w/ RIPP headers, Diablosport Trinity, 6 1/2" Teraflex, 38 KM2s, Trail Readys, RCVs, JE Reels, Currie Antirock, Redneck Ram, ORH Top, Bushwacker Flares, XRC 10 Comp, EVO 1/4 Pounder, Finishlinewest Rear Carrier/Bumper, Rotopax, Schrockworks Rails, OverKill Corner Armor, Rock Hard/AEV Skids, Warn VTC, ARB Fridge,.....
Bubblegoose1 is offline  
post #7376 of 24842 Old 06-06-2011, 11:55 AM
kjamesm
Registered User
2010 JK Wrangler 
 
Join Date: Dec 2008
Location: Arlington
Posts: 56
A preview of what i started yesterday after playing around in the woods. Painting all the wheels in black and did the calipers in red, leaving the "jeep" center caps silver and the lugs will be chrome to. Ill post better pics tonight when im done.
Attached Thumbnails
IMG-20110605-00359.jpg  

2010 JK
2.5 RC BB
1.5" spacers
315-75-16 Duratracs
kjamesm is offline  
post #7377 of 24842 Old 06-06-2011, 12:12 PM
Redtwo
Registered User
2008 JK Wrangler 
 
Join Date: Mar 2011
Location: Hooper
Posts: 138
Brought her home

Redtwo is offline  
post #7378 of 24842 Old 06-06-2011, 12:12 PM
JcArnold
Registered User
1990 YJ Wrangler 
 
Join Date: Mar 2010
Location: Pflugerville
Posts: 718
Quote:
Originally Posted by kjamesm View Post
A preview of what i started yesterday after playing around in the woods. Painting all the wheels in black and did the calipers in red, leaving the "jeep" center caps silver and the lugs will be chrome to. Ill post better pics tonight when im done.
What paint are you using? Ive been thinking about doing the same thing

1990 YJ Islander without the Island so I guess that makes it just an " er "
2010 JKU Sahara Super Lift 4", 33" Nitto Mud Grapplers, Custom Front bumper and rocker protection-SOLD
2012 Jeep JKU MW3 Edition Rubicon



37x12.50x17 Goodyear Wrangler MTRs
Pro-Comp 7031 17x9
Rock Krawler 5.5" X-Factor
Fox Racing Shocks
Synergy Front Cage Kit
Synergy Axle Tubes/C gussets
4.88 gears frt/rr
Replacement frt/rr driveshafts
Poison Spyder rockers
And a bunch of other little stuffs
JcArnold is offline  
post #7379 of 24842 Old 06-06-2011, 12:20 PM
jdcouts
Registered User
2010 JK Wrangler 
 
Join Date: Jan 2011
Location: Evansville
Posts: 38
Quote:
Originally Posted by jeeperjk View Post
Is it itsy bitsy teenie weenie yellow polka dotted?
jdcouts is offline  
post #7380 of 24842 Old 06-06-2011, 12:23 PM
goldenglory18
Registered User
 
Join Date: Apr 2011
Location: Los Angeles
Posts: 818
This weekend I spent close to 20 hours upgrading the stock stereo.

Polk dxi6500 components in the front
Polk dxi650 two ways in the roll bar
JL XD400/4 amp
RE-q5 bass processor

Not as easy as I originally thought, but I sure did learn a lot about Chrysler electrical systems :kill me now:

Gone and I dont miss it at all - 2011 JKU
goldenglory18 is offline  
Reply

Tags
accessories , diy , diy jeep mods , image , JK Wrangler , modification , wrangler

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the JeepForum.com forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid e-mail address for yourself.



Email Address:
OR

Log-in









Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.




Currently Active Users Viewing This Thread: 2 (0 members and 2 guests)
 
Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page



Similar Threads
Thread Thread Starter Jeep Forums Replies Last Post
I had fun today! Burnerman YJ Wrangler Technical Forum 9 06-18-2014 06:12 PM
Not a good day today. :( CHRRRIS TJ Wrangler Technical Forum 35 09-17-2013 02:39 PM
what i did to my tj today? shovelhead Wrangler General Discussion 6 11-05-2012 12:22 PM
Hit by Bus Today Cooneys08JK JK Wrangler Technical Forum 32 01-07-2012 03:30 PM
New today AZGreenMonster YJ Wrangler Technical Forum 7 09-02-2010 07:52 PM

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome