Originally Posted by awinski
looks great painted. you have a press to bend those corners?
thank you. hahaha funny u asked that. I C clamped the metal to a shop table. scored the back of it with a grinder (where I was going to make the bend) and heated it with a torch....then took a BFH to it. took a lot of sweat and aggravation but it bent. These were made with an angle grinder, c clamps, drill, rivets, and paint. The metal is 6mm thick...so a tad over 1/4 inch. I`m in england so I have to buy metal as close as possible to inches in a metric conversion.