Ok. Corbeau seats as per my seat install thread!
Now it finally going in for some roll bar work!! I decided i want it all to fit within the half cab. At first i was going to add some bolt in bars for show but thats out. I want it in the style of the mopar jk8 roll bar but with more support. Brian , "the roll bar guy" as he is known in the household here said he can do it. The idea is to go with his heavy wall 1 3/4" pipe. It will fit into the existing support with the seat belt bracket and welded.
It will then direct 90 degree on a slight angle to the plates in the floor once utilized by the back seat.
I would then like a bar like the mopar has along the bottom except welded in as a bar slightly above the bulkhead for the half cab.
Heres a pick of the mopar bar being installed buy a dealer I believe.
This is the angle it will take to the plate for welding. With the cross bars added it should look pretty good!
Heres is the mopar cut off point inthe top bar
and the bulkhead placement markings
Tomorrow we strip the interior!!