[sprtplt]

Anyone install this and it fit right? It seems to bind and not lay down compared to the stock piece, I attached the compass module correctly and it is just not fitting right. ('07 Sahara) Is there a trick to this? thanks

[CGScotty]

Mine went in just fine. Where are you saying its binding or not laying down. It is a little taller I think to make up for the compass on the underside and still have the storage for the top.

[Maximus O]

I couldn't get mine to fit either. I'm returning it tomorrow.

[sprtplt]

It will only go all the way down if forced, the factory piece just lays down with no effort.

[JaKe08]

I installed mine last November and it fits perfectly. No problems here!

[paul olllllllo]

mine is fine too. Are you sure you are tucking it in enough in the front?

[CrotalusAtrox]

Mine didn't even come close to fitting. I had to relocate the GPS antenna and Dremel the plastic frame that the front of the Daystar part mounts to.

PJ

[ge2]

Mine fit perfectly too-- though the only wire I had underneath it was the compass module wire.

Looks like I may have to remove it though, in favor of the stock one, to get my sport cage to fit.

[Brent_f70]

mine fit fine but really messed up my compass reading.....Apparently I am always traveling East now??

[ge2]

Mine didn't mess up my heading at all. I haven't looked into it in the Jeep, but in my old fords, the manual gave very precise instructions on how to recal the compass. Have you tried that yet?

[jeepjonesin]

Mine fits perfectly and I did notice that my compass reading started to not work correctly. Found in the 08' manual <pg 214> how to complete a manual calibration of the compass. My zone was still set to the default of zone 8 instead of 9. Changed, completed calibration and working normally now.