well i havent got a cj7 yet but im working on finding one. i cant seem to fid one in my area. its rough but i'm working had on getting one. so if anyone knows where i can find one in the areas around syacuse new york id like to know. i just need body and frame. thanks guys!
Rolled stinger for front bumper, coped the pipe with a torch. Then I cut the trusses for the side. Booyah! Oh and got inspection sticker and tag. STREET LEGAL!! WOOT BTW-- If anyone could find something out for me... I need to know if it's illegal to ride on the road without the doors in Mississippi?? pm me plz
BAIL! "Welder's have hotter rods"
Arc-Up Welding Inc.
i am not goin to list all the mods here but check out my profile for a more indepth look, but long story short, 46 Cj 3a. springoverlift, 35" Dunlops, chev 3/4 ton axles(narrowed), 350 Ci, built up trans and xfercase, many race parts,but i wont try and list em all, Any Q & A bout engine or Axle swaps, lemme know
replaced the thermostat and water pump. next task is to replace the clutch master/slave cylinders and the radiator. then I drive it and see what else needs to be tweaked or even replaced/fixed. just trying to remain patient right now is all. sucks to buy the jeep only to have it sit in a garage for two weeks now but I'm definitely leaning a lot mechanically. it'll get there. mahalos all, joel
installed centra-pod box n spkrs that a friend gave me along with some duraliner and two spray guns... Gotta take it back out to finish my tub, radio, wiring and everything dash... jut wanted to see what it looked like...
Took a vacation so have been puttering on it all week. So far I have replaced the front seat belts, checked the timing, replaced the spark plugs, and rebuilt the carb (Holly 650 cfm). Tomorrow I will repair the passenger seat frame and hopefully enjoy it a little before I have to fix something again.