My Buddy is changing a 3spd trans to a T18-1e. The front shaft is'nt long enough to fit into the pilot bushing. Has any one run into this problem? Does anyone know if and where a longer pilot bushing can be bought ?
Originally Posted by BOSSMAN1967
Here are a few sources that you can try, you may have better luck just calling them on the phone and telling them what you need. They are are all very helpful!
1982 cj7. Frame off. shell valley kevlar body, stainless hinges, Bestop seats and supertop, KC titanium lights, Homemade swing out tire carrier with spare front wheel bearings/hub, Built 304,DUI,Edelbrock shorty headers with dual stainless 21/2 tubes into incynerator cans 21/4 dumped out the back,Edelbrock 600cfm, performer intake and cam, Borgeson lower column, Centerforce clutch, NV-4500, Dana 300 w/custom built twin stick, Homade 1/4" steel skid plate, 2.5 soft ride w/ 1" shackle lift, 33x12.5 mtr's. Stainless fuel and brake lines, Braided hoses. more...
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Thread||Thread Starter||Jeep Forums||Replies||Last Post|
|Cj pilot bushing||Bahama Blue||Jeep CJ Forum||5||01-03-2008 08:05 AM|
|Pilot Bushing ?||coyote7791||Jeep CJ Forum||4||07-29-2007 06:53 PM|
|t 18 pilot bushing||the shootist||Jeep CJ Forum||4||09-04-2006 05:40 AM|
|Pilot bushing||Bulletproofcj7||Jeep CJ Forum||20||09-05-2004 08:36 AM|
|pilot bushing||kdub47||Jeep CJ Forum||0||05-22-2003 12:53 PM|