-   Jeep CJ Forum (
-   -   CJ of the Month Submissions (

BESRK 07-01-2011 04:56 PM

CJ of the Month Submissions
Post your submission here. Cut/paste the spec list (below) into your post and accompany it with 2 pics. Post the pic below the specs. Failure to follow instructions will get your post deleted.

Submissions will be accepted until somewhere around the 15th of the month at which point the thread will be closed and Voting will take place until the last day of the month.. then the winner will be named.

This is for the Ocotber 2014 CJ of the Month..


Year of CJ



Transfer Case

Front Axle

Rear Axle



Additional Mods

vsanzbajo 09-12-2014 05:38 PM

2 Attachment(s)
Specs: Jeep CJ 7 Laredo

Year of CJ: 1986

Engine: 4.2 L 6 CYL Mopar FI

Transmission: 5 Speed Manual T5

Transfer Case: Dana 300

Front Axle: Dana 30

Rear Axle: Dana 44

Suspension: Rancho RS 5000 with 3 inch Lift

Tires: 33s All Terrain

Additional Mods: Mopar FI

1tonmut 09-15-2014 01:52 PM

2 Attachment(s)
Specs-Cj7 laredo


Engine-5.0 ford roller cam v8

Transmission-4 speed T18 with 6.32:1 granny low

Transfer case-Atlas II with 5:1 low range

Front axle-Dana60 4.56:1 shortened 4",posi,springless kingpins,flange yoke

Rear axle- GM 14 bolt full floater 4.56:1 spooled

Suspension-Spring over lift,wrangler 3" springs,shackle reverse,limiting straps

Tires-37" H1 surplus tires on recentered H1 beadlock wheels w/inserts

Additional mods-
9,500 lb winch with 100' arachni synthetic winch line.
Anti wrap bar on rear axle.
Crossover steering with high psi P pump and fluid cooler.
108watt led light in front and a dozen 3watt led's underneath for crawling lights.
H4 headlight conversion with 130 watt high beams off road.
Poison spider body wrap and rocker knockers.
Flush mount tail,turn,brake lights and matching style front turn signal lights
15 gal fuel cell and regulated recirculating fuel system.
Braided steel hoses with AN fittings on fuel lines,vac booster line,brake flex lines.
Heater craft mojave heater.
Front roll cage.
Crawling bumpers.
Co2 and air compressor.
Cut front fenders narrower 3", 3" tube flares in rear.
Aluminum radiator.
dual cv drive shaft up front , cv drive shaft in rear.
Remote oil filter and oil cooler.
Just installed GoPro.
And I did 99 percent of it myself !

Mlaughlin8 09-16-2014 11:34 AM

2 Attachment(s)
Specs: jeep cj5 trail rig

Year of CJ: 1980

Engine: rebuilt 4.2ltr bored .060 over, header, magnaflow exhaust, gm ignition, weber carb, flow cooler water pump, optima red top

Transmission: t176 rebuilt to stock specs

Transfer Case: rebuilt Dana 300

Front Axle: rebuilt Dana 30, warn hubs, 3.54 ratio

Rear Axle: model 20, 3.54 ratio, tom woods cv driveshaft

Suspension: 4" superlift springs, rubicon express shocks, steering box brace, braided ss brake lines, procomp drop pitman arm, 1" shackle lift front, 1/2" shackle lift rear, 1.25" day star body lift

Tires: 33x10.5x15 bfgoodridge km2, 15x8 ultra gauntlet wheels

Additional Mods: built roll cage off of factory rollbar, corbeau seats, marine stereo, home built bumpers, rocker gaurds, tire carrier, and gear mounts, herculiner paint that has held up extremely well! Milemarker 8000 winch. Warn lights 2pr.

The time now is 10:23 AM.

Powered by vBulletin Version 3.8.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.