Jeep Enthusiast Forums banner

Floor problems

512 views 4 replies 5 participants last post by  NOC Bulldog 
#1 ·
Ok so i am considering taking the carpet out of my jeep but i was wondering what you guys did to the metal floor; left it bare or recovered it with something. Please give me some ideas! Pictures appreciated.
 
#4 ·
i just redid mine, although it was nothing like these pictures, i gutted the jeep, sanded the floors to bare steel and primed them, then gave them a shot of fresh silver and put the carpet back in after thoroughly soaping it and 5 hours of air drying, looks like new again.
 
#5 ·
Started out with this mess........

passenger side


driver side


Then Herculined the whole tub


Put the carpet back in, all good! Be carefull when welding the new panel in, doing a continuous bead will warp the pan. Treat the underside of the pan when you're done, otherwise it will crap out again. :highfive:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top