The rears are factory.. But when I got done with the lift with the factory front springs on it had a bad lean to the left. After a bit of research I went with the rancho ra44044 front springs. Setup nice after that.
Last week I got new tires. They are stock size goodyear wrangler radial's.
Then I started working on my front hitch/snow plow mount. The center reciever will come out just under the front bumper, and will be the mounting point for the hydrolic pump for the plow. It's just tacked together in the pics, and I need to get the bumper back on to determine where the rest of the mounting points need to be placed.
maroon 1987 Grand Wagoneer. stock for now...
replaced all the tie rods did a tape measure alignment drives perfect dead center. Saturday I'll finish the front end rebuild with new sway bar bushings, and rebuilding the driver side knuckle, bearings, ball joints etc. Finished passenger side this past Monday.
then I'll swap my hard riding rough country shocks for the Rancho rs9000 adjustable units I have waiting.
06-Corvette z51-6spd,b&b,K&N low miles.
77-Corvette Stingray 496 BBC/TH400 built 667hp+
00 WJ 4x4, 4.7 stroker, turbocharged,..lots more..
01 WJ 4x2 4.7v8 Limited (needs valve job)
90 Grand Wagoneer 401 Edelbrock Heads, Lunati .510/.527 FT Cam, Edelbrock RPM Air Gap, Holley HP 750, Thorley Headers, HEI, Electric Fan w Digital controller,4" lift 31x10.50 Goodyear Duratrac's on Pro-Comp Wheels,new interior, seats,seals,Alpine and JL full system, Remote HEI, Clifford 2 way with remote start,windows,tailgate.
96 Cherokee Country 4dr/2x2 White/Tan 3" Lift Sahara 18" Wheels 32.5"'s 99up head and intake- for sale soon!
Does anyone know anything about the throw out fork in the wagoneer? I have to replace it but the new one looks nothing like the old one, can I replace it without replacing the throwout bearing and everything?