Peckin along with Clawed. Ball joints, new tie rod and Pittman Assm. steering gear, MSD streetfire, Optima yellow top, repair tranny lines to cooler. On to the rear brakes
Whew. Ok rear brakes done after 2nd wheel cylinder on drivers side (1st one leaked BAD). Cleaned up the engine bay wiring. Installed matching body color lug nuts, and played with the RKE some more (cuz I can)
"I like fun" Edd
Clawed: 90GW, TFI, Streetfire, 3"lift all spring, 31"BFG ATs, working RKE, Edel2131, Holly 1850, mild cam,
05 Renegade OME 927, 947, top plate, JBA 4.5s
"Just Jeepin it real"
Tried replacing the y-pipe in the exhaust. Broke 3 of the 4 off as expected. Zero room to work to pull the old ones ones. May have to replace the manifolds which will then create even more work. Should have left them alone.
91 Grand Wagoneer(Winter vehicle/project)
Prior 08 Wrangler JK Lifted-Miss her
Installed new headliner! Thanks to Steve @ SMS Headliners for making a great product. Just a quick install tip - suggest removing the center trim piece right away - makes fitting everything much easier, and since it just snaps out/in, saves a lot of headache. Old one was NASTY...by the way, anybody know where to get a replacement cargo light switch? as you can see, mine is broken...
06-Corvette z51-6spd,b&b,K&N low miles.
77-Corvette Stingray 496 BBC/TH400 built 667hp+
00 WJ 4x4, 4.7 stroker, turbocharged,..lots more..
01 WJ 4x2 4.7v8 Limited (needs valve job)
90 Grand Wagoneer 401 Edelbrock Heads, Lunati .510/.527 FT Cam, Edelbrock RPM Air Gap, Holley HP 750, Thorley Headers, HEI, Electric Fan w Digital controller,4" lift 31x10.50 Goodyear Duratrac's on Pro-Comp Wheels,new interior, seats,seals,Alpine and JL full system, Remote HEI, Clifford 2 way with remote start,windows,tailgate.
96 Cherokee Country 4dr/2x2 White/Tan 3" Lift Sahara 18" Wheels 32.5"'s 99up head and intake- for sale soon!
Re-torqued my suspension today. The top bolts(the one that is attached to the frame)to one the rear shocks was super stripped and the nuts got stripped also. I tried teflon and new nuts but it didn't work. I'm thinking I'll stop by the hardware store and grab several different sized nuts and see if any of those will do the trick.
anyone on here have any other options I should check out?
bored at home so i cut the stock exhaust off right b4 the cat "btw pipe size is 2.50" clamped on a flowmaster with a turn down sounds amazing!!! "autozone $129" also did the fog light mod so i can run my fog lights with hi beams, got a k&n really didnt want to but needed a airfilter asap. r2 my u joints fwd and aft. r2 the chattering throw out bearing wasnt bad at all kinda sucked doing it alone lol.