This may have been addressed before but filtering through 500 pages of Q&A.....erm yeah........so I'd like something of this nature as far as scratch resistant and to get the whole exterior the same color black or blue or whatever. Armor upgrades have made it a slight camo type coloring as I never get the same kind of black twice. lol Here's my fear: My Silverado I had before the Jeep had Line-x and it was a biscuit to wash because the dirt/dust/grime would get caught within the texture and pretty much never get fully out. Gave it a dirty appearance I really didn't like after a wash. The benefits of driving through the desert. Does your product always come in textured even if sprayed on? I don't want 4000 grit sand paper baby butt smooth but smooth enough to wash and coat with spray on wax for protection/longevity would be awesome!!! Like flat paint without the clear coat. Any info would be much appreciated on this.
The texture is dimpled and not created by addition of those large "rubber" type particles. Look at ll the pictures. They are dimples. The texture is smooth. Maybe a little more textured when sprayed. Again, look at the pictures. I posted some close ups as have others. No comparison to additive based castings.
Therios Pendragon aka Ken Johnson
2003 maroon Jeep Wrangler SE - Soft top
Hard half doors
-New Bestop replacement
-Orfab front bumper (DONE)
-CRS rear bumper
-CRS rear bumper tire mount swing arm.
-led third light mods that sit in the two spare tire lug holes.
-because of above - removed ugly third light tower completely
-smitty top end grab handles
-20" LED light bar 10 degree spot (installed now and blindingly operational)
-50" LED light bar 20 degree flood ( changed to 30" in center 3 tabs, installed but not wired)
-windshield mount light bar (done)
-winch 8000# smitty
-Monstaliner complete pan in red head(as soon as they deliver it) (done)
-corbeau RS reclining seats
-corbeau water proof seat covers
-corbeau seat mount replacements (removes tilt forward passenger seat)
-AXD 430 receiver [url]http://www.crutchfield.com/p_070AXD430/Axxera-AXD430-CD-Receiver.html[/url]
-hood hinge mount for my hi lift jack
-tremendous mt 31.5/10.5 15s on nice alloy rims
-Everything else is stock... For now
Led dash replacements
Led square lights for 6 free mounting tabs
Led backup lights
Ok Thanks Guys. This isn't in the near future but it's being saved for.
Next up I guess would be chassis saver. I'm assuming it would take 4 gallons to do exterior, interior, and bottom of the tub once it's lifted off the frame. Maybe add another gallon and do the frame rails, axles, diffs, and everything while it's off and the opportunity presents itself. Does this sound like a sound approach to doing this all correct for longevity of the Jeep?
Edit: Also, what type of media can this be sprayed on? I know metal but is there any plans for something that can be applied to a more porous surface to get the dash and trim to a nice offsetting color to complete/protect that part of the vehicle too? (Note to vendor: That would be a monumental selling point for a lot for people.)