Dana 60 High Steer Arms. Blue Torch FabWorks

[BlueTorch]

Blue Torch Fabworks has high steer arms for kingpin Dana 60 Axles. We offer them for rod end and Tie Rod End (tre) applications. Our arms are machined from 1-1/4 inch thick cold roll steel plate. It has a seperate cap that bolts to the top of the arm. We also have moly stud kits sold seperatly. We also have a double steer arm for behind the axle tie rod location.






We not only sell our products we make them. We run these products on our own rigs and can answer any tech questions you may have. If you need to know anything please let us know.

-Dan

[sjlplat]

Hey Dan,

I'm running one of your old-style D60 arms on my rig now, and I got a steal on a JB Conversions arm awhile back, so I figured I'd give that a shot for the other side. Well, it would have worked out perfect, but the damn heims were just too big to fit right, so I had to move the tie-rod forward a notch on the passenger side. Of course, this screwed my ackerman angle, and I'd like to remedy that. Will a new arms work in conjuction with the old style, or would I need to buy a pair?

[BlueTorch]

Originally Posted by sjlplat

Hey Dan,

I'm running one of your old-style D60 arms on my rig now, and I got a steal on a JB Conversions arm awhile back, so I figured I'd give that a shot for the other side. Well, it would have worked out perfect, but the damn heims were just too big to fit right, so I had to move the tie-rod forward a notch on the passenger side. Of course, this screwed my ackerman angle, and I'd like to remedy that. Will a new arms work in conjuction with the old style, or would I need to buy a pair?

They close to the same. They are thicker so they will be a little taller. Give me a call when you get a chance and we will see what we can work out. I may still have an old one laying around somewhere

-Dan

[BlueTorch]

We have both styles in stock ready to ship. Supply is limited so let us know what you need.

Thanks
Dan