Looking at building my own bumpers. I can't seem to figure out how far in/ out from the edges the clevis should be mounted. Can any one help me out?
Same width as your frame and inline with the frame.
A 89 yj with a 4.0 aw4 sye out of an 92xj. Now the hard part is done time to get it up in the air just a bit. Working on 8.8 with 3.73 and lsd for the rear. and new D30 hp with 3.73 .
For those who have not figured this out I'm old school but can handle the new too.
At my work, they had switched from Solidworks to Inventor just before I got hired. Some of the old SW guys have had a hard time switching over, and they just love to ***** and complain about Inventor, and recall how easy SW was. I've been using only Inventor for the past 10 years. I guess ignorance is bliss.
My YJ/CJ V8 Magnum Build: http://jeepforum.com/forum/f22/magnum-force-mopar-mans-build-1412306/