Talked to my Brother-In-Law this weekend. His plotter can cut out the logo any way we want it.
Have you thought about what size it should be? Send me the file and I'll forward to him to get a couple samples printed. I'm going to try and make it Saturday, but it all depends on what time we start in the morning at work. Thanks!!
Sent you my email via PM
Logo sent to your email.
I would have him print it on white vinyl and trim around the entire thing and leave a 1/16th inch white line around the outside edge if he can.
That's just what I had in mind for mine.
When it is sized it is roughly 7 inches wide by 4 inches tall. Any sizing should scale with those sizes up or down accordingly.
It looks good. The white boarder was the way to go. Waiting to hear everyone's opinion. If we decide this is the one, I need to let him know by Thursday to have them ready for Saturday. Good job on it!!
This is a very rough idea to approximate a concept. I did not spend the necessary time to clean up all the edges, make the lines all flow or anything else, I am just putting this out there as food for thought.
so I dug into my front end today. checked the u joints, diff fluid, greased all the joints. I also checked all the bolts were tight...found a loose bolt on the steering stabilizer and the track bar. I also rotated the tires and checked the alignment while I was at it.
an the verdict!....death wobble is still there. damn.
I found that the steering box has some play in it tho. so I'm thinking my next step is to do the dodge Durango steering box swap.
| 3.5" RE Lift | 315/75R16 BFG KM2's | Dana 30 w/ Lockrite | Dana 44 | Metalcloak Front Bumper | Smittybilt Rocker Armor | Knockoff Warn Tire Carrier | Rokmen Shorty Corners |