|
 |
|
|
|
>
Warn XD9000 Lies Dead in My ARB.
| Introducing MONSTALINER™ UV Permanent DIY Roll On Bed Line | TJ 5.25" Speaker Adapters - NalinMFG | Truck-Lite's New LED Headlamp Series |
 |
11-06-2009, 02:02 PM
|
#31 | |
|
Registered User
2008 JK Wrangler
|
No wireless yet. I think I am going to leave it alone for a while. The cable still looks good. When that goes, I will give rope a try. I think the only other thing I am planning to get for my winch now is a cover.
|
|
|
|
|
|
|
09-16-2011, 06:47 PM
|
#32 |
|
Registered User
1994 YJ Wrangler
|
i know this is an old post, but if anyone pays any attention to it, i need to re-clock the position of my free spool shift lever on my xd9000 warn winch. i just bought and installed an ARB bull bar on my yj and the shift lever is not facing directly upward.
thanks dan |
|
|
|
|
09-19-2011, 01:26 PM
|
#33 |
|
Vendor
 
|
Dan,
To do this you will want to stand the winch up on end so the housing is straight up in the air. Remove the 10 screws from the end housing then you can lift it up about a ¼" and rotate it every two holes to the desired position. Reinstall the screws and you are done. - Andy |
|
|
|
|
| Thread Tools | |
|
|
|
«
Previous Thread
|
Next Thread
»
|
| Suggested Threads |
|
 |
|
|
Jeep, Wrangler, Cherokee, Grand Cherokee, and other models are copyrighted and trademarked to Jeep/Chrysler Corporation. JeepForum.com is not in any way associated with Jeep or the Chrysler Corp.
|
