San Diego Area - Page 993

premo · 07-28-2009, 03:30 PM

Quote:

Originally Posted by RikRotorhead

http://inlandempire.craigslist.org/cto/1292786418.html

DAMMIT!!! i just spent a stupid amount of money this weekend (mom flew to town) then paid off my credit card...TODAY! or id pick this up!

Jeebs · 07-28-2009, 03:31 PM

I've sold enough parts to buy a Cherokee. I still have the axles, TC, engine, tub and frame too!

**jbolty** · 07-28-2009, 03:38 PM

Quote:

Originally Posted by Jeebs

I've sold enough parts to buy a Cherokee. I still have the axles, TC, engine, tub and frame too!

Or, you still have enough parts to build a CJ and now extra money to do it.

**Grewe02** · 07-28-2009, 05:08 PM

Man you guys post in this thread way too much!

**4x4Outcast** · 07-28-2009, 07:04 PM

Quote:

Originally Posted by RikRotorhead

It doesn't have a motor or trans in it, but I'm gunna' try. If they want to see it then it's a different story.
I would definately like to keep it as a 50 Willys reg.

They will not want to see it. You walk in and tell them "here's money" and they say Thanks...

Quote:

Originally Posted by Jeebs

I've sold enough parts to buy a Cherokee. I still have the axles, TC, engine, tub and frame too!

Did you sell the fuel cell??

Quote:

Originally Posted by Grewe02

Man you guys post in this thread way too much!

Don't be a hater....

Just post more...

**Grewe02** · 07-28-2009, 07:08 PM

Heh. Yeah I suppose I could.

Since I'm here, after I find a place I'm going to be working on the Heep quite a bit. Definitely will need a few extra hands to get it started.

Send me a tell next time any of you have some wrenching that needs done.

**4x4Outcast** · 07-28-2009, 07:35 PM

How can someone find out what the fine is for CVC 5201??

I got a PARKING ticket for improper display of license plate but listed it under the catch all "others" violation which is listed at $40.00. I put my plate in the front window (parked) because I changed my front bumper (that did not have a mount location) to let whom ever know that I had the plates.

I want to dispute the amount of this ticket because it should only be listed as a "fix-it ticket" or a lower fine amount.

I really hate those parking nazi's. They write tickets for whatever they can just to get a quota and make the government money. When one got a ticket a long time ago it was for a serious violation or meter violation. Now a days that has changed to make money for the government (city, county, state, whatever). Just drive down a road (or street) and look around, I bet you see at least one parking ticket or speeding ticket being issued.

Jeebs · 07-28-2009, 08:24 PM

Quote:

Originally Posted by Grewe02

Heh. Yeah I suppose I could.

Since I'm here, after I find a place I'm going to be working on the Heep quite a bit. Definitely will need a few extra hands to get it started.

Send me a tell next time any of you have some wrenching that needs done.

You looking for some built axles? I have a pair that'll bolt right in!

**RikRotorhead** · 07-28-2009, 08:43 PM

Quote:

Originally Posted by Brett77

I replaced the clutch in my YJ last May by myself. ( not true my sweet young bride was the legs for my beer that day) With a jack stand under the tranny. I seperated the transfere case and the Tranny. (hand full of bolts) And balanced the transfere case with one hand while lowering /operating the floor jack with the other hand, a 231 is not that heavy. Then moved the jack stand from under the tranny to under the motor. With a block a wood on the floor jack I pulled the tranny while balancing it with one hand and operating the floor jack with the other. Note: the center line of the tranny is not the center of the wieght distibuted inside the tranny. The floor jack was postioned alot farther towards the rear of the tranny than you might think... I've done it both ways, with the Tranny and Tcase married up and seperated. I like them seperated. The weight your are working with is greatly reduced. Clutch Alignment tool Clutch Alignment tool Clutch Alignment tool, you need a Clutch Alignment tool. Makes life a bunch easer
When I went back together I had a floor jack under the motor which was a big help in aligning the input shaft of the tranny to the pilot bearing. The T case was a breeze to line up. It sounds easier than actually doing it and there is always a health measure disciptive language involved.

I can't lift a load that is very heavy (surgery), but I'm pretty sure with all the jacks and jack stands I have it will come out pretty easy with some help to balance it.
The kit I purchased came with the alignment tool. I know how to cuss a lot, so I'm sure that will help too.
Thanks for your input.

**4x4Outcast** · 07-28-2009, 08:44 PM

Quote:

Originally Posted by Jeebs

You looking for some built axles? I have a pair that'll bolt right in!

Tell me it's not that RUST colored thing in the parking lot.....

**RikRotorhead** · 07-28-2009, 08:45 PM

Quote:

Originally Posted by 4x4grey88

How can someone find out what the fine is for CVC 5201??

I got a PARKING ticket for improper display of license plate but listed it under the catch all "others" violation which is listed at $40.00. I put my plate in the front window (parked) because I changed my front bumper (that did not have a mount location) to let whom ever know that I had the plates.

I want to dispute the amount of this ticket because it should only be listed as a "fix-it ticket" or a lower fine amount.

I really hate those parking nazi's. They write tickets for whatever they can just to get a quota and make the government money. When one got a ticket a long time ago it was for a serious violation or meter violation. Now a days that has changed to make money for the government (city, county, state, whatever). Just drive down a road (or street) and look around, I bet you see at least one parking ticket or speeding ticket being issued.

First thing I do when I buy a cer is take the front license plate off. Never got a ticket yet (knock on wood). But yeah, it's supposed to be a fix-it ticket. Go to the court and get it straightened out. Get a cop to sign the ticket before you go.

**RikRotorhead** · 07-28-2009, 08:48 PM

http://inlandempire.craigslist.org/cto/1294409273.html

And another one.....

http://inlandempire.craigslist.org/cto/1293860191.html

And also.....

Why the hell would somebody do this?

http://inlandempire.craigslist.org/cto/1294405001.html

**Grewe02** · 07-28-2009, 08:55 PM

Quote:

Originally Posted by Jeebs

You looking for some built axles? I have a pair that'll bolt right in!

Eventually down the road, yep. But for now I'm focusing on making loud noises with it.

What do you have to offer? The 30 and 20?

Jeebs · 07-28-2009, 09:20 PM

Quote:

Originally Posted by Grewe02

Eventually down the road, yep. But for now I'm focusing on making loud noises with it.

What do you have to offer? The 30 and 20?

PM sent!

**Motorep** · 07-29-2009, 01:07 AM

Any wrenching parties coming up? I just bought a Currie setup for the front of the Jeep and need to install it. Upper and lower control arms, track bar, and Currectlync steering system. I have the garage to do it but wouldn't mind meeting some other SD Jeepers.