Jeep Enthusiast Forums banner

Local stuff for sale/stuff wanted/free stuff

142K views 2K replies 127 participants last post by  paulhead 
#1 ·
Started over again. The other thread was pretty full of expired stuff.

Just for the SoCal SD/Riverside/Orange/L.A. county areas.

Post what you have, how much?
Post what you need.
 
#525 ·
the flange can be changed, I believe there is an atlas flange that works. and there are Tone rings available to connect to the VSS. you will need some sort of converter to convert the signal to the proper ratio... but it has been done.

a buddy of mine has a JK 241 in his XJ. he is a machinist so he made the tone ring himself.
 
#526 ·
lots of write ups ... here, pirate, and other sources. Do a google search. Anything can be done, but a TJ rubi 241 for a TJ is much easier. Change the front output to a 1310, fix the wiring connector, address the tranny mount issue and your pretty much done. This might be a project I'll be doing next yr. I need to slow down for now.....
 
#549 ·
Hey guys. I'm in riverside county

Got some currie 1" lift motor mounts. $65obo

RE hack and tap rear cv driveshaft for 4cyl yj $140obo
all you need is this shaft and the flange from rubicon express


I think I got some other stuff. I'll post up When I get it sorted out

:thumbsup:
 
#555 ·
Holding my TJ Dana 30 ARB RD30 for a buddy for one wk. If he can't get the money together it'll be up for grabs. 300.00
Also have dana 30 inner axles 50.00 for the pair
4.56 gear set for LP dana 30 100.00
(3) BFG KM2 tires.. 99% new 35x12.50x17 275.00 ea.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top