Made these rear quarter panels today. Not done yet but got a good dent in em. Hope they come out good in the end. I used a plasma to cut them out then cleaned em up with a grinder. They were pretty rusty. I used 1/8" steel for them. Its not hard. They take some time though. You could use a grinder with a cut off wheel and a flap disk for them, you dont need a plasma cutter. I used rivets because they look BADASS and they hold well. I siliconed the top and sides of the NOT the bottom. I used 1/8" steel plate and aluminum rivets. If I did it again I would used half as many rivets though. It looks kind of busy to me.
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.