Ok So... i got my RC 4.5" Military Wrap Springs in and got them on last night here are a few things to note,
One - I was told they were 4.5" springs .... Not True they are 3.5" springs and with the kit you get a set of 1" shackles.
Two - if you have stock shackles they will not fit, and if you have anything other than Their lift shackles they may also Not work.
Ok so here is a Before and After shot of the front and rear
One would think that since i have a set of 1" lift shackles i should see the same lift or more than before but NO I got Less than before ??
Now on to the shackles, as i said you might run into problems as in my case.
Mine have a short and a long side i have the short end Up in the front and it works fine However in the rear the short end will not fit up at the frame so they have to face down.
This is where the problems are, the cross bar gets in the way of the mill wrap so i had to take the sleeve out and just put the bolt in
but in the front with the short end up its fine
So i put about 25miles on the jeep last night with the new springs and i can say they are MUCH SOFTER Of a ride and i will be hitting a trial or two today to try and flex them out and will let you know how they work