The Jeep made it back out to CO over the weekend. I replaced the head gasket and a t case bearing and seal before making the trip but didn't have time to finish the HP30 build. That's still sitting in my garage back in MN.
Also, I ordered some parts for the jeep today:
4" round tail lights
A yj fuel bezel
Some misc hardware
Moab Fab (soon to be called Stewy Fab) rocker guards (my passenger guard is dickered)
And finally....some custom Moab Fab Corners made to my specs
Specs on the corners include the following:
Centered for 98" wb/5" stretch
CJ Tailgate Conversion
Notches for TJ Sliders
Countersunk Mounting Holes
4" tail light holes
YJ Fuel Bezel in the factory TJ location
wheel well oversized 2" and raised .5"
They will look something like this
I'm pretty excited to cover up some trail damage and be better armored in general. If the level of customer service at Moab Fab is any indication of the quality of this armor, I think I will be thoroughly satisfied with my purchase.
I think so too. Did you end up using nutserts when you installed them? Or just the provided nuts and bolts?
You need nutserts in 4 places on each side. The 3 holes along the door frame and the bottom corner at the tailgate. The tub is double walled in those places. Everwhere else I just used the supplied hardware, though I got button head bolts instead of countersunk bolts.