Jeep Enthusiast Forums banner

Gauge cluster will not work

314 views 0 replies 1 participant last post by  Krobar3493 
#1 ·
I recently put in LEDs under my dash and I wired
Them into a hanging wire. But I found out that when I applied the brake they would shut off and when I released the brake they turned back on. But when I un spliced them, my gauge cluster shut off. And now only works if I take the two hanging wires and touch them together and apply my brake. Can someone help me get my gauges back!?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top