As for mounting, I think it was a PITA. Even with a right angle attachment, there wasn't enough room to install the braces to the outside "frame" near the pinch seam. I ended up heading over to the muffler shop for a couple stitch welds. That side is only for supporting standing on the sliders. No bolts on the pinch seams at all, they are up under the door sill (where I welded them).
The inner rails attached fine, but at the angle its hard to get the bolts started. And I cant stress enough, DO NOT OVERTIGHTEN! that sheet metal is very thin.
I will need to update this soon. I have in my garage awaiting install:
Aussie Locker for the 44A
IRO Transfer Case skid
JKS Quick Discos
Tom Woods front Double/Single DS
and sometime this year the delivery for my KOR roof rack and Rear Stealth Bumper with tire carrier.
i think it will too, i love the look of the rear and sides of the bumper, i like the high/straight sides for some reason. i actually didnt like it when i looked at it on protofab's website, but this has changed my opinion 100%.
mind if i ask how long it took to receive it after ordering? and where did you get it directly through protofab?
2000 White V8 WJ LSR-6in-35's-LA's-242HD-Warn [B]SOLD and missed very badly[/B]
06 GTO - BC Coilovers, JBA Catless mids, Svede Intake
Midshipmen Patrick 1/C USMMA DD: 2004 Golf GLS TDI 43mpg and 2002 Overland: Zone 4in, 32in Treadwright MTRs, IRO upper CAs, lift gate light mod, Alpine/Polk speakers, and power inverter with USB in dash mod, CB, custom rear swing out tire carrier Build thread [url]http://www.jeepforum.com/forum/f22/apollo21-build-thread-902929/[/url] SOLD