[488TJ]

im in the process of building a rear end and wanted to see what axle splines dodges ran in there dana 60 rears?? thanks mike

[Fastbeeatch]

Depends on year mine was an 81 and it had small spindle bore, if I remember right late 80's is what you are looking for. I am not 100% sure Jason will chime in with the right year I'm sure

[Fastbeeatch]

Just read your other post about the 60 I guess Jason does'nt know after all, still 81 is small bore.

[jason m]

Originally Posted by Fastbeeatch

Just read your other post about the 60 I guess Jason does'nt know after all, still 81 is small bore.

ya i never really ran into to much Dodge stuff. I know the in's and out's with the fronts but rears i allways skipped over, Unless they were dana 70's. Like i said in the other post take your shafts and slide one in and see or just messure it with a Mic.

I know the 60U will have it all your looking for.

Jason.

[488TJ]

ya jason and i talked quite a bit one the other thread i had going, figured id ask anyone else out there who new dodges!!

like i told jason, my roomate has a 2000 dodge 2500 with a d60 and i wanted to try it!! i told him today to rip his axle out and find out... called me back saying his is a 30 spline but his spindles are boared big, he slide my 35 spline axles in and said it fit with a little bit of play!!!

knowing that my question is will my ford d60 carrier with 9 3/4 ring fit in that dodge d60 that also has 9 3/4 ring????

[jason m]

Originally Posted by 488TJ

ya jason and i talked quite a bit one the other thread i had going, figured id ask anyone else out there who new dodges!!

like i told jason, my roomate has a 2000 dodge 2500 with a d60 and i wanted to try it!! i told him today to rip his axle out and find out... called me back saying his is a 30 spline but his spindles are boared big, he slide my 35 spline axles in and said it fit with a little bit of play!!!

knowing that my question is will my ford d60 carrier with 9 3/4 ring fit in that dodge d60 that also has 9 3/4 ring????

Yes it all should fit, just make sure its not a dana 70 with 32 spline shafts. There easy to get confused in the spline count.

Jason.

[488TJ]

thanks !