Dropped mine off to get some of the welding done for my long arms! Anyone have a rough estimate what just the welding would cost for just the rear clayton long arms?
And is it ok to run different backspacing front and back?
97 ZJ 5.2L, NP231, 6"ish lift, 33" KM2s, hp30, IRO front long arms, Clayton rear long arms, JKS quick discos, BDS Shocks, Flowmaster Super 10 Series muffler, KOR style bumper
Build Thread - [url]http://www.jeepforum.com/forum/f22/blacked-out-zj-low-budget-1159489/index2.html[/url]
pulled the trans. swapped the pressure plates. and still nothing. so i pulled the master/slave assembly and returned it. didnt think it was bled properly and it had no bleed screw. went ahead and ordered one from the dealer. putting it in sunday
1996 ZJ- 4.0, [COLOR="Purple"]AX-15 5SPD/NP242[/COLOR], RE 4.5" lift, 36x12.50x16.5 Goodyear military surplus tires, Longarms/Tri-4 link/one ton axle build/swap in progress, arb bumper, a bunch of other goodies
1995 XJ- 4.0 HO, ax-15(stolen for swap), stock
2001 GMC Sonoma-RIP...
2002 GMC Sierra 1500 ECSB-roadtrip/long haul vehicle
[CENTER][COLOR="Blue"]RIP Troy (bigbluezj94) you wont be forgotten[/COLOR]
[COLOR="Purple"]December 2010 GCOTM[/COLOR]
5spd ZJ Club Member 001
[QUOTE=bddisi;6376248]Glad you are ok. If you were a cat, you would be down to 8.:D[/QUOTE]
Got stopped on the way home from base today, and was offered $6500 for it. Apparently the young soldier had just purchased a ZJ, but didn't want to go through the process of building it. I pointed out the flaws mine has, mainly a crank 185k mile 5.2L, and he was still unfazed. I had to laugh the offer off, and told him I had more than that in it currently, and it's not even close to done.
There is only a liquid gasket in the rear diff right?
Used black rtv and autozone had a felpro gasket for the rear d35 and d30 front 4$ each so I got both. napa and advance auto said they could only get it for the d30 and d44. When I took it apart all that was on both was a **** load of rtv and some red locktite