Jeep Enthusiast Forums banner

Winch mounting question

567 views 7 replies 6 participants last post by  frumpy 
#1 ·
I just went to mount up my winch and the bolts holding the winch to the winch plate are hitting the stock bumper. Question is, am I ok just to put some washers in there? Its either that, build spacers, or notch out the bumper.
 
#4 ·
I drilled holes through the bumper and used that as an extra strength point. It did however make remounting the bumper about 80 pounds heavier:D
 
#6 ·
I just crawled out from under my jeep from installing my winch. I cut me some spacers.
Funny, there has been an onrunning thread here for 2 days, started by me, about this very subject. laugh:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top