What did you do to your YJ today? - Page 117 - JeepForum.com

 1285Likes
 
LinkBack Thread Tools
post #1741 of 71300 Old 02-05-2008, 10:09 PM
ryanbaker13
Junior Member
 
ryanbaker13's Avatar
1993 YJ Wrangler 
 
Join Date: Jan 2008
Location: Knox, IN
Posts: 25
Garage
...OK, so after a few too many Cap'n & Coke's, I decided that 11 p.m. is the prime time to remove the back seat... and seatbelts... and re-position my sub... and piss off the neighbors by adjusting the audio settings to make sure new sub position sounds the best...


RUBICAN'T!
Fantastic4 cyl., 5 spd., 3 in. B.L., 31 in. Super Swamper TSL's on steel, KC SlimLites, Cobra CB, no spare, no fender flares, no front sway bar...
ryanbaker13 is offline  
Sponsored Links
Advertisement
 
post #1742 of 71300 Old 02-06-2008, 12:55 AM
renegade10s
Registered User
1995 YJ Wrangler 
 
Join Date: Oct 2007
Location: salem oregon
Posts: 108
After i replaced certain parts of my vacuum hoses and then spent a hour trying to get the t-case switch out. i finally got my 4wd to work by switching the rubber hose connector on the front axle backwards it...actually...worked. till i bumped into my moms POS van and bent my fender and did nothing to her car. What can i say? i was so amazed it actually worked i stared at the 4wd drive light for a little to long!!!!!

free water!
renegade10s is offline  
post #1743 of 71300 Old 02-06-2008, 07:42 AM
ufatbastehd
Registered User
2000 TJ Wrangler 
 
Join Date: Feb 2004
Location: nYc
Posts: 1,028
New rear license plate holder.

Real tough took 3 minutes
ufatbastehd is offline  
post #1744 of 71300 Old 02-06-2008, 10:54 AM
pthrift
Registered User
2013 JK Wrangler 
 
Join Date: Jan 2008
Location: Danville, VA
Posts: 84
weight reduction. stage 2.

started underneath with a hose pipe. cleaned out about 5 LBS of mud (PO liked to take her muddin everyday and half a.. clean it up).

problem is; after 2 hours of spraying; i still have LOTS left to do; but the yard had enough extra dirt.....
pthrift is offline  
post #1745 of 71300 Old 02-06-2008, 12:41 PM
Mowgli
Registered User
 
Mowgli's Avatar
1989 YJ Wrangler 
 
Join Date: Jan 2008
Location: Taxachusetts
Posts: 97
installed new oilpan & gasket w/ss hardware

replaced the new fuel pump gasket with 2 stuck together w/a slight film of rtv - slight film

Maybe it'll finally quit marking it's territory

Early YJ Club, Member #5

Dipstick Yellow '89 YJ * 258 * 131,xxx * Paid $1K * Weber
Nuttered * automatic * GSA's on stock steelies for winter
Bestop seats & flares * Tuffy glove & center * Optima yellowtop

'88 Turbo Mighty Max 4X4G63t 300HP sleeper - FOR SALE! - Turbo Truck Video
Primo Winter Beater '92 Mighty Max 4X4

Quote:
Originally Posted by The Hun
"Political Correctness" is a doctrine, fostered by a delusional, illogical, liberal minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end.
Mowgli is offline  
post #1746 of 71300 Old 02-06-2008, 02:45 PM
Solus
Registered User
1990 YJ Wrangler 
 
Join Date: Dec 2007
Location: Texas
Posts: 356
Found out that my vacuum leak is not coming from a vacuum hose but from the rebuilt carb. And my cutting out while accelerating hasn't stopped. But! The jeep has more power! So yay...
Solus is offline  
post #1747 of 71300 Old 02-06-2008, 07:25 PM
njdpb22
Registered User
1989 YJ Wrangler 
 
Join Date: Jan 2008
Location: Old Bridge NJ
Posts: 102
ripped my exsuast out from after the headers. WOW I ACCUALY DRIVE GRAVE DIGGER! it sounds so sick. but to bad im going to be NJ's most wanted. its too loud to drive around town in. So gunna have to buy new pipes and new muff.

Ripped out emissions crap that doesnt work
njdpb22 is offline  
post #1748 of 71300 Old 02-07-2008, 06:12 AM
TxRex
Registered User
 
TxRex's Avatar
1997 XJ Cherokee 
 
Join Date: Nov 2007
Location: Crosby
Posts: 69
Tried to chase down a blinker problem when all the lights are good (driver side works, but not passenger)

Dropped her off at the trim shop to forgo the headache of putting on a bl myself, they're also throwing in mounting my new brush guard for free


_________
[l_|__\_i__\,__
l--___--[=lllllll=]
()_)' '()_)---)_)

1997 XJ- 3.5 Skyjacker + 31" Pro Comp All Terrains

RIP - 1988 YJ - Gone but not forgotten
TxRex is offline  
post #1749 of 71300 Old 02-08-2008, 07:45 AM
TxRex
Registered User
 
TxRex's Avatar
1997 XJ Cherokee 
 
Join Date: Nov 2007
Location: Crosby
Posts: 69
BL on, looks great! Trim shop said I had 4 body bolts already snapped when I brought her in. Would explain the bone jarring rattle goin down the road. BL brought new life into the feel of the ride!

Got my new seatbelts in and installed, also got my Tuffy underseat security drawer installed and the back seat put back in


_________
[l_|__\_i__\,__
l--___--[=lllllll=]
()_)' '()_)---)_)

1997 XJ- 3.5 Skyjacker + 31" Pro Comp All Terrains

RIP - 1988 YJ - Gone but not forgotten
TxRex is offline  
post #1750 of 71300 Old 02-08-2008, 10:30 AM
richharr
Registered User
1993 YJ Wrangler 
 
Join Date: Mar 2007
Location: NYC
Posts: 405
did nothing finally, now I just have to wait for it to break.

93 4.0l 5 spd, 33s 4" lift
Quote:
1. This forum requires that you wait 60 seconds between posts. Please try again in 1 seconds.
richharr is offline  
post #1751 of 71300 Old 02-08-2008, 03:19 PM
Stout95YJ
Registered User
2006 LJ Wrangler 
 
Join Date: Sep 2007
Location: Wilmington
Posts: 821
drove 219miles to carolina beach
Stout95YJ is offline  
post #1752 of 71300 Old 02-08-2008, 08:04 PM
leedurr
Registered User
 
leedurr's Avatar
1987 YJ Wrangler 
 
Join Date: Jan 2008
Location: Virginia Beach
Posts: 61
Well lets see. I did an internal to external clutch slave swap and replaced my pinion bearings in the rear after I found the pinion loose when I dropped the trani. I think that would b enough for 2-3 days....lol. Oh wait I changed the U-joint too....

Lee

87 YJ, 4.5 RE lift with monotube RE shocks, 33 LTB's, 258 w/4.0 head, HEI, and Weber carb, Header, Comp 252H cam, Dynomax, cat back and much more.......
leedurr is offline  
post #1753 of 71300 Old 02-08-2008, 08:31 PM
Ryanpowell167
Registered User
1992 YJ Wrangler 
 
Join Date: Feb 2006
Location: Elk City
Posts: 648
Quote:
Originally Posted by TxRex View Post
BL on, looks great! Trim shop said I had 4 body bolts already snapped when I brought her in. Would explain the bone jarring rattle goin down the road. BL brought new life into the feel of the ride!

Got my new seatbelts in and installed, also got my Tuffy underseat security drawer installed and the back seat put back in
What they meant to say was, "sorry we broke 4 body mount bolts when we tryed to break them loose with the impact after they sat undisturbed for over a decade..."

Black 1992 wrangler, 40" creepy crawlers, d60/14b 350tbi/700r4/np205, spring over on 4" springs.
2011 Ford F-150 Raptor, whipple supercharged...
Ryanpowell167 is offline  
post #1754 of 71300 Old 02-08-2008, 10:06 PM
Mowgli
Registered User
 
Mowgli's Avatar
1989 YJ Wrangler 
 
Join Date: Jan 2008
Location: Taxachusetts
Posts: 97
POR-15ed the front floor pan.
I think I'll stay out of the garage for a few days.
Glad it's not my DD.

Early YJ Club, Member #5

Dipstick Yellow '89 YJ * 258 * 131,xxx * Paid $1K * Weber
Nuttered * automatic * GSA's on stock steelies for winter
Bestop seats & flares * Tuffy glove & center * Optima yellowtop

'88 Turbo Mighty Max 4X4G63t 300HP sleeper - FOR SALE! - Turbo Truck Video
Primo Winter Beater '92 Mighty Max 4X4

Quote:
Originally Posted by The Hun
"Political Correctness" is a doctrine, fostered by a delusional, illogical, liberal minority and rabidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end.
Mowgli is offline  
post #1755 of 71300 Old 02-09-2008, 04:21 AM
jeep63
YJ Collector
 
jeep63's Avatar
1989 YJ Wrangler 
 
Join Date: Nov 2005
Location: Baltimore
Posts: 781
Removed the Teraflex revolver shackles front and rear and replaced with currie shackles (boomerang in the rear). Starting prep work for the TJ rubicon flares I just purchased and then I am off to remove the 2" BL and install the daystar 1" poly BL with integrated body mounts. My mounts are kind shot after 20 years.

In April I start work on the belly-up project.

jeep63 is offline  
Reply

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the JeepForum.com forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid e-mail address for yourself.



Email Address:
OR

Log-in









Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.




Currently Active Users Viewing This Thread: 4 (3 members and 1 guests)
cKruzer , csmit328 , ShadowSentry
Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page



Similar Threads
Thread Thread Starter Jeep Forums Replies Last Post
Not a good day today. :( CHRRRIS TJ Wrangler Technical Forum 39 08-14-2016 04:08 PM
I had fun today! Burnerman YJ Wrangler Technical Forum 9 06-18-2014 06:12 PM
what i did to my tj today? shovelhead Wrangler General Discussion 6 11-05-2012 12:22 PM
Hit by Bus Today Cooneys08JK JK Wrangler Technical Forum 32 01-07-2012 03:30 PM
New today AZGreenMonster YJ Wrangler Technical Forum 7 09-02-2010 07:52 PM

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome