What did you do to your YJ today? - Page 110 - JeepForum.com
Search  
Sign Up   Today's Posts
User: Pass: Remember?
Advertise Here
Jeep Home Jeep Forum Jeep Classifieds Jeep Registry JeepSpace Jeep Reviews Jeep Gallery Jeep Clubs Jeep Groups Jeep Videos Jeep Events Jeep Articles
Go Back JeepForum.com > Models > Jeep Wrangler Forums > YJ Wrangler Technical Forum > What did you do to your YJ today?

Artec Holiday Sale!Bead Lock Wheels! Raceline, Trail Ready, & Trail-GearROCKRIDGE4WD Introduces a NEW Jeep Wrangler JK *led* tail

Reply
Unread 01-20-2008, 09:56 AM   #1636
BuffaloYJ
Registered User
1999 TJ Wrangler 
 
Join Date: Aug 2003
Location: Chicago, IL
Posts: 517
Installed my new APN Header! I finally know what my muffler sounds like!

__________________
________________________________________
'94 4.0, AX-15
2.5" suspension lift, 1" shackle lift, K&N FIPK w/ AEM Dryflow, APN header, Smittybilt Front, Olympic Rear w/ carrier, Poison Spyder Corners

Buffalo born and bred, now in CA.
BuffaloYJ is offline   Reply With Quote Quick reply to this message
Unread 01-20-2008, 06:19 PM   #1637
Mr.B
Wot's...uh The Deal?
 
Mr.B's Avatar
1994 YJ Wrangler 
 
Join Date: Nov 2005
Location: Roseville, Ca.
Posts: 3,335
I haven't posted in this thread in awhile
Took the spare tire and carrier off the bumper today. Then rattle canned all the rusty spots. I don't plan on getting more than 100 miles from the house for the rest of the winter. AAA can tow me if I should happen to have a flat.

I went from this:



To this:



Then I crawled underneath, and found this. Wonderful!

__________________
.
White '94 YJ 2.5L 5 speed, 35" BFGs KM2's, 5" lift, Mark VII 2 speed fan, Milemarker PE8000, Front Aussie Locker, Power steering conversion, '98 Cavalier seats, MORE Boomerangs in front, 136 amp ZJ alternator, JB conversions SYE, Tom Woods custom drive shaft, 8.8 with ARB, 4.88 gear ratio, Teralow

My Jeep

'89 XJ Laredo Bone Stock

Member:The Wrecking Crew

Ham license:
KB6(tooeasytosearch)

Everyone is Welcome
www.rubiconramblers.com

Quote:
Originally Posted by Major Sanderson
You have no respect for excessive authority or obsolete traditions. You're dangerous and depraved, and you ought to be taken outside and shot!
Quote:
Originally Posted by Beefstew
I may have proven that I am in fact an idiot, by all of your standards...
Quote:
Originally Posted by ritjobbie View Post
Mr.B's post gets you as close to Buddha as you can get on JF...
Mr.B is offline   Reply With Quote Quick reply to this message
Unread 01-20-2008, 06:48 PM   #1638
RoverJeep90
Registered User
1990 YJ Wrangler 
 
Join Date: Mar 2006
Location: Columbia, Maryland
Posts: 837
I installed my body lift today. Need to go get some hose, but other than that I'm glad to have that pain in the butt installation over with.
__________________
1990 Red YJ 2.54 L (Rebuilt) 5 Speed with 94 rollbar | Dynomax Exhaust | Luk Clutch
2.5" Old Man Emu over 31x10.50 BFG MTs on 15x8 AR 767s | 1" Daystar Body Lift
Two Tops | Full and Half Doors | KC Daylighters | Hella 5500 | OME Steering Stabiliser
Sony CDX-GT300 | Kicker ZX500.1 | Kicker ZX350.4 | Kicker ZX200.2 | Kicker L5 Solobaric Sub | Kicker 6x9's | Apline 6.5's | Boston 4x6's
Truckstop CB Antenna | Class 3 Hitch
RoverJeep90 is offline   Reply With Quote Quick reply to this message
Unread 01-20-2008, 06:57 PM   #1639
Jeebs
Registered User
2001 XJ Cherokee 
 
Join Date: Nov 2007
Location: Over there
Posts: 3,387
Completed the Herculiner install this week. I took my time, stripped everything and made sure it was done right. Lucky for me my YJ has ZERO rust. The PO babied the thing. Anyway, here are the before and after pics.



__________________
San Diego Group
Jeebs is offline   Reply With Quote Quick reply to this message
Unread 01-20-2008, 07:03 PM   #1640
hdfxrs91
Registered User
1987 YJ Wrangler 
 
Join Date: Mar 2006
Location: FL
Posts: 687
Had to rebuild the power steering pump, got it installed, then took a test drive.
hdfxrs91 is offline   Reply With Quote Quick reply to this message
Unread 01-20-2008, 10:25 PM   #1641
jeep n00b
Registered User
1995 YJ Wrangler 
 
Join Date: Jun 2006
Location: new jersey
Posts: 147
mounted the 31" bfg M/Ts i told you guys about a few pages ago. they were a real pain to balance, but they're on my rig now lookin' good. they look real nice with the stock aluminum 5 spoke rims! next on the agenda: steering box and lift kit.
__________________
1995 YJ wrangler, 4 cylinder, 5 speed manual, posi-lok, BFG mud terrains 31x10.5x15.
1988 pontiac trans am GTA, 305 5.0L V8, 700R4 auto, 3.27 posi rear, WS6 level 3 suspension.
jeep n00b is offline   Reply With Quote Quick reply to this message
Unread 01-20-2008, 10:27 PM   #1642
YJ_Pat
Registered User
1989 YJ Wrangler 
 
Join Date: Feb 2007
Location: Fresno, CA
Posts: 56
Replaced fuel filler hose and cowl seal.
__________________
"Beer is living proof that God loves us and wants us to be happy." -- Ben Franklin
YJ_Pat is offline   Reply With Quote Quick reply to this message
Unread 01-20-2008, 10:43 PM   #1643
Alabamaranger
Registered User
1990 YJ Wrangler 
 
Join Date: Sep 2006
Location: Leeds AL, Alabama
Posts: 1,715
Things out of hand

Installed hood vents and stripes on my 90 - last week

On my son's 87, replace the Master Cylinder, Adjust rear brakes, front body bushing replace and than tap the lower steering shaft bearing back in place until I can replace it, tighten leaking clamp on the heater hose.
Last week - nutter by-pass and install new axle seal on the front right Dana 30 shaft.

Alabamaranger is offline   Reply With Quote Quick reply to this message
Unread 01-20-2008, 10:57 PM   #1644
PhatForrest
Registered User
2006 LJ Wrangler 
 
Join Date: Nov 2006
Location: Waterford, CT
Posts: 107
Changed the oil and went wheeling.
__________________
92 YJ, 2.5 l/o, 4" Lift, 33" Super Swampers, Superwinch EPi9.0, Aussie Locked Dana 30, Uniden pro510xl CB and Firestik antenna, Hi Lift, Tuffy Center Console, Miller Lite tap handle shift knob, 40mm ammo can tool box, chains, straps, etc. - Sold to a good home

2006 Wrangler LJ.
PhatForrest is offline   Reply With Quote Quick reply to this message
Unread 01-21-2008, 08:51 AM   #1645
TxRex
Registered User
1997 XJ Cherokee 
 
Join Date: Nov 2007
Location: Crosby
Posts: 69
Ripped off all the old pads of the roll bars, ripped all the carpet out, replaced the spark plugs and wires, took off the side steps, gave her a bath, then took her through some mud!
TxRex is offline   Reply With Quote Quick reply to this message
Unread 01-21-2008, 11:31 AM   #1646
jeep couple
Registered User
2002 TJ Wrangler 
 
Join Date: Oct 2006
Location: virginia
Posts: 251
Finally installed the 4.0L Tb in my 2.5L. Made a difference that i could feel right away. Next on the list is the electric fan install.
__________________
2002 Jeep Wrangler TJ X; Smittybilt SRC front bumper, Warn M8000, 16x8 Rubicon Moabs on 31" Goodyear MTR's, 2.5" RC Proggressive lift, JKS Quick Disconnects, A to Z Rockers, Warn Steering Skid, 4WD rear bumper/tire carrier.


Buy local seafood and support your local fisherman!
jeep couple is offline   Reply With Quote Quick reply to this message
Unread 01-21-2008, 12:25 PM   #1647
Samgler
Registered User
2000 XJ Cherokee 
 
Join Date: Jun 2006
Location: Chicago
Posts: 272
Ur lucky man. Looks like you had it easy. Looks great.
Quote:
Originally Posted by NewBlue90
Completed the Herculiner install this week. I took my time, stripped everything and made sure it was done right. Lucky for me my YJ has ZERO rust. The PO babied the thing. Anyway, here are the before and after pics.



__________________
________
l_l_,[____],
l---L-- []lllllll[]-
(o)_) (o)_)=o)_)
^^^^^^^^^^^ 1995 YJ Sahara, 4.0L 5spd

Rubicon Express 4.5 extreme duty lift, SYE, Tom Woods custom drive shaft. Mickey Thompson MTZ 33x12.5R15 on d windows.
Samgler is offline   Reply With Quote Quick reply to this message
Unread 01-21-2008, 04:02 PM   #1648
RedRenegade93
Registered User
1993 YJ Wrangler 
 
Join Date: Jan 2008
Location: Toronto Canada
Posts: 45
Nothing too special, took the front seats out and compared mounting spots with some Mazda Protege5 seats I want to swap in. The seats fit in the stock location and should clear the roll bar but unfortunately the sliders don't line up. Now I have to decide if it's worth it to attach some kind of new mounting plates.
RedRenegade93 is offline   Reply With Quote Quick reply to this message
Unread 01-21-2008, 09:14 PM   #1649
BIGHEEP
Registered User
1988 YJ Wrangler 
 
Join Date: Dec 2007
Location: Chester, New Hampshire
Posts: 305
Opened the garage door, looked at it for a minute, then retreated to the warm house. Darn this cold weather. It's 13 degrees and my YJ sits.
__________________
1981 Scrambler, Vortec 350,4L60e,D300, Currie 9" F&R
19xx YJ/CJ/TJ/XJ/Waggy thing 4.0L H.O., AW4,
NP231 w/HD SYE,D44 locked/D44 w/LSD,4.09 gears
Build thread http://www.jeepforum.com/forum/f12/m...igheep-534340/
North East Willy Jeep Organization
www.NEWJO.ORG
BIGHEEP is offline   Reply With Quote Quick reply to this message
Unread 01-21-2008, 10:23 PM   #1650
92YJer
Registered User
1992 YJ Wrangler 
 
Join Date: Apr 2007
Location: Riverside, California
Posts: 30
Had the top painted black

92YJer is offline   Reply With Quote Quick reply to this message
Reply

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the JeepForum.com forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid e-mail address for yourself.
Note: All free e-mails have been banned due to mis-use. (Yahoo, Gmail, Hotmail, etc.)
Don't have a non-free e-mail address? Click here for a solution: Manual Account Creation
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.


Thread Tools


Suggested Threads





Jeep, Wrangler, Cherokee, Grand Cherokee, and other models are copyrighted and trademarked to Jeep/Chrysler Corporation. JeepForum.com is not in any way associated with Jeep or the Chrysler Corp.