Originally Posted by Renegade88
Thanks Mr.Renegade88 ! Truly a fun project.
When you consider all the little parts. Clips, special bolts, wiring, misc hardware etc. you need to identify then source. It becomes a real jigsaw puzzle.
Recall we had no donor YJ to start with so all the parts had to be figured out. Heater cables, ductwork, dash, windshield wipers and linkage, steering. Even the frame engine mounts. As the frame was a 4 cylinder set up.
Then mix in the aftermarket stuff and it was a grand experience and a heck of a neat project.
Plenty of fab work with the cage, skid plates. Driveshafts, mounts for the NV4500/Atlas. Mounts for the OBA, hydroboost and PS resivoir. Towers for the front shocks etc etc.
The YJ has continued to evolve and as time and $$ permit. It is built upon. Right now all the wiring has been stripped out and is being replaced with heavier gage and new connectors/terminals.
After the wiring. A set of HP60`s are sitting under it awaiting to be built. They have been re tubed already but need to be finished off. Hopefully by spring.
Thanks for your vote and hope to see you on the trail !!
Don`t forget the official Jeep wave !!