i googled it not much there. i would get a Haynes or Chiltons manual, too much involved without directions. IMO removing the tranny = a pain in the a$$ job. might as well replace the clutch while in there. must be a thread here somewhere with more detail..........
Do you have an internal or external slave? I have had mine in and out a few times and each time I did it on my own. I second the advice on doing it on concrete, rocks and grass are no fun.
78 cj7, 434hp 350. th400, 2" lift, dana 44s, 32" bfg ats
02 wj dd
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Thread||Thread Starter||Jeep Forums||Replies||Last Post|
|NVG3550 noises....Input bearing or throw out bearing?||ROLLTIDEtj||TJ Wrangler Technical Forum||44||09-03-2014 06:07 PM|
|Input shaft bearing or Throw out bearing?||reisom||TJ Wrangler Technical Forum||20||04-21-2011 09:19 AM|
|Pilot bearing & Throw out bearing??||gregb||TJ Wrangler Technical Forum||39||06-18-2010 12:44 PM|
|throw out bearing?||00jeepred||TJ Wrangler Technical Forum||7||07-12-2009 11:56 AM|
|Throw out bearing||jeep97medic||TJ Wrangler Technical Forum||4||02-05-2009 06:17 AM|