Well, after reading the entire thread I decided to take the challenge. My driver seat had most of the foam rubber gone and the passenger side cover torn in many places. Went to Jalopy Jungle and found several Cavaliers. Years from 92 thru 2002, 2drs and 4drs. Found a 97 2dr. as the first prospect. I checked and the seat did not fold forward any further than the 4dr ones. It was in good condition but pretty dirty. Found a 4dr 98 that had nearly perfect seats. $38 plus tax and I owned both front seats. I only had time this evening to change one seat so started on the passenger side. Removed the YJ seat with no effort. Put it on the PU tailgate. Removed the bolts from the Cavalier seat tracks and went to remove the Jeep seat tracks. Crap! Torx on the Jeep! Went to Walmart and bought a torx set. Removed the rear torx easily but couldn't figure out how to get to the front bolts. After about 10 minutes of screwing around with foam etc I finally moved the seat track back and there they were! Removed and held the cavalier track to the jeep seat to see how the bolt holes lined up.. Crap again! The bolt holes were about an inch off! Well, guess Have to drill. More effort. Studied for a while again and discovered I had it upside down! Put it the correct way...Hurray! Mounted the Jeep seat mechanism to the Cavalier seat perfectly! Yes indeed, an easy bolt in. I will do the other seat tomorrow after work and post pics! Thanks for the encouraging thread!
On the 7th day...God went 4wheelin'!