i'd like to but i only got a flux core and minimal talent with welding, my welds look like popcorn with sprinkles.
Thanks for the sig
[SIZE="1"][URL="http://www.jeepforum.com/forum/f22/04-tj-high-school-budget-my-build-thread-1145642/"][COLOR="Blue"][B]My Build Thread[/B][/COLOR][/URL]
[B][URL="http://www.jeepforum.com/forum/f43/introducing-monstaliner-uv-permanent-diy-roll-bed-liner-875162/"][COLOR="Blue"]MONSTALINE'D for Life![/COLOR][/URL]
[URL="http://stu-offroad.com/support.htm"][COLOR="Blue"]I Supported Stu![/COLOR][/URL][/B]
High School Jeepers #361
Parrothead Jeep Club #46
[QUOTE=XJ-Tim;12621151][SIZE="1"]my welds look like popcorn with sprinkles.[/SIZE][/QUOTE]
[QUOTE=Benjamin Franklin][SIZE="1"]Beer is proof that God loves us and wants us to be happy.[/SIZE][/QUOTE]
just get the jcr basic and then grab some flat stock and make your own tie ins....or just wait and save the extra $50 and get them which is prolly better/cheaper in the long run with the cost of sourcing the steel, cutting it and mocking it up.
I have the olympic front receiver bumper. It was something like $230 on quadratec. It's worked great so far, but you'll need to put your own d-rings on it. Here's some pictures right when I installed it. It's been tightened down and sits flush now:
The brackets on the front are for the tow bar. Just drilled and bolted on with Grade 8 hardware. The front valence is off and fenders have been trimmed back too. Like here: